300-610 Exam Dumps Free Test Engine Verified By CCNP Data Center Certified Experts
Use Real Cisco Achieve the 300-610 Dumps - 100% Exam Passing Guarantee
Cisco 300-610 certification exam is designed to test professionals' knowledge and expertise in designing Cisco data center infrastructure. Designing Cisco Data Center Infrastructure certification exam is ideal for IT professionals who are interested in expanding their knowledge of data center infrastructure design. 300-610 exam covers a wide range of topics, including data center design, network design, storage design, compute design, and automation.
NEW QUESTION # 88
Refer to the exhibit.
The Cisco Nexus Series Switch with hostname Nexus! is the default gateway for server A and server B Both servers must have reachability to the internet; however, server A internet traffic must pass through the firewall for deep packet inspection. Also, the firewall must inspect any communication between server A and server B. Which solution must be applied to separate the data plane path for server A and server B?
- A. VDC
- B. VLAN
- C. VXLAN
- D. VRF
Answer: D
NEW QUESTION # 89
What are two reasons to select OTV as the DCI solution to connect multisite topologies? (Choose two.)
- A. It propagates hosts reachability without support of traffic flooding.
- B. It is an open standard.
- C. It constrains HSRP hello messages to each data center.
- D. It extends the spanning tree between data centers.
- E. Layer 3 failures do not propagate beyond the OTV edge device.
Answer: D,E
NEW QUESTION # 90
What influences the number of ISLs that are required between Cisco MDS Series switches?
- A. N Port virtualization
- B. FCoE protocol
- C. end-to-end oversubscription ratio
- D. type of storage
Answer: C
Explanation:
The number of ISLs required between Cisco MDS switches will depend on the desired end-to-end oversubscription ratio. The storage port oversubscription ratio from a single storage port to multiple servers can be used to help determine the number of ISLs needed for each edge-to-core connection.
NEW QUESTION # 91
Refer to the exhibit. A cloud service provider deployed three geographically separated Cisco ACI data centers. One of the customers needs to host a clustered application that is spread across the three data centers. The cluster nodes that host the application need a Layer 2 topology to communicate with each other.
Which Cisco ACI topology design meets these requirements?
- A. Multi-Pod over OSPF EVPN
- B. Multi-Pod over MP-BGP EVPN
- C. Multi-Cloud
- D. Multi-Site
Answer: D
Explanation:
Each data center has its own APIC cluster. This is multi-site setup.
NEW QUESTION # 92
An engineer must connect a Cisco UCS B-Series based system to an existing large storage area network fabric. The deployment must support hardware-based load balancing, prevent Fibre Channel domain ID exhaustion, and enable all blade servers to be in the same VSAN.
Which set of actions meets the requirements?
- A. Configure Ethernet end-host automatic load balancing on the fabric interconnect.
Set NL port mode on the SAN switch. - B. Enable Fibre Channel end-host mode on the fabric interconnect and NPIV mode on the SAN switch.
Create an F Port channel that faces the fabric interconnect. - C. Connect the fabric interconnect to the E Ports on the SAN switch.
Create a SAN port channel. - D. Place all interfaces that face the fabric interconnects in the same VSAN.
Disable zoning for the VSAN.
Answer: B
NEW QUESTION # 93
An engineer deploys LISP VM mobility. Which feature is configured on the interfaces that have VM mobility enabled?
- A. proxy ARP
- B. HSRP
- C. flow control
- D. IP redirects
Answer: A
NEW QUESTION # 94
An engineer is configuring a Cisco UCS Service Profile template for an environment that will host Windows servers Some of the servers require access to a Fibre Channel storage network The design requires the server HBA to send the maximum number of commands to a Fibre Channel disk using a single transmission Which action must be taken to meet these requirements?
- A. Set LUN Queue Depth to 240
- B. Increase Max Data Field Size to 2096
- C. Disable 10 Timeout Retry
- D. Decrease Link Down Timeout to 20.000
Answer: A
NEW QUESTION # 95
A customer needs a design for a new network VLANs must be dynamically provisioned based on the information received from connected hosts No Layer 2 or Layer 3 configuration must be performed on the related switch ports. Which feature must be used?
- A. POAP
- B. VM Tracker
- C. Network PnP
- D. iPXE
Answer: B
NEW QUESTION # 96
Which feature provides a sandbox to convert NX-OS CLI commands to REST-based scripts on Cisco Nexus 7700 Series Switches?
- A. Guest shell
- B. NX-API
- C. Bash shell
- D. Postman
Answer: B
Explanation:
https://developer.cisco.com/docs/nx-os/#!nx-api-cli-developer-sandbox
NEW QUESTION # 97
What is a design consideration when implementing FSPF?
- A. FSPF runs only on F Ports.
- B. Routes are based on the domain ID.
- C. Routes are based on the distance vector protocol.
- D. FSPF runs on a per-chassis basis.
Answer: B
Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/ fabric/nxos/cli_fabric/fspf.html
NEW QUESTION # 98
The management of the Cisco Nexus switches is provided over an isolated put-of-band network. The VDC feature is configured on the Cisco Nexus core switches. How is out-of-band management access provided for each VDC?
- A. All the VDC have the same out-of-band IP address.
- B. Each VDC has a unique out-of-band IP address from the same IP subnet.
- C. Each VDC has a unique out-of-band IP address from different IP subnets among VDCs.
- D. Each VDC has a dedicated out-of-band Ethernet management port.
Answer: B
Explanation:
Section: Network Design
NEW QUESTION # 99
Refer to the exhibit. A Cisco engineer is configuring a data center design scenario with Cisco MDS 90Q0 Series Switches. The cut-through routing mode is chosen for impf oved read operation performance. Each (SCSI host requires access lo storage through the IPS module. First, the engineer configures the TCP tuning parameters as enabled SACK, the maximum bandwidth of 1 Gbps. buffer size of 4096. keepalive timeout at
1s. and enables Path MTU. Then, the engineer must set the OoS of the ISCSI link. What is the maximum QoS value that must be set tor the ISCSI session?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 100
An engineer requires a solution that achieves Ethernet traffic forwarding on all available paths from the hosts to the Cisco Nexus Fabric Extender and from the Fabric Extenders to the Cisco Nexus 5000 Series Switches. The NIC teaming from the Fabric Extender to a server should use an LACP EtherChannel. Which solution should be implemented to meet these requirements?
- A. Enhanced Virtual Port Channel
- B. Virtual Port Channel
Answer: A
Explanation:
C. Virtual Port Channel Plus (vPC+)
D. Back-to-Back Virtual Port Channel
NEW QUESTION # 101 
Refer to the exhibit. Two Cisco Nexus 9000 Series Switches exchange OSPF routing information with R1.
Which action accomplishes this goal?
- A. Add peer-gateway under vPC domain.
- B. Add layer3 peer-router under vPC domain.
- C. Add layer3 peer-router under vPC interface link.
- D. Add peer-gateway under vPC interface link.
Answer: B
NEW QUESTION # 102
A network administrator must create a redundant vHBA for the mission-critical virtual machines (VMs) installed on a Cisco UCS Fabric Interconnect blade server. The VMs access multiple datastores using VSAN55 and VSAN95. The datastore on which the VMs are hosted must be accessible if any of the uplinks goes offline. Which action meets these requirements?
- A. Enable failover for the vHBA with VSAN55 and VSAN95 enabled.
- B. Configure load-balancing for vHBAs with VSAN55 and VSAN95 attached.
- C. Assign VSAN55 and VSAN95 to vHBA1 and vHBA2.
- D. Attach VSAN55 to vHBA1 and VSAN95 to vHBA2.
Answer: D
NEW QUESTION # 103
A SAN fabric is built between a pair of Cisco MDS 9000 Series Switches. The requirement is for the ISL to use the VSAN ID to toward traffic from multiple VSANs across the same physical link. Additionally, the Fibre Channel trace feature must be supported. Which ISL interface parameters are required to meet these requirements?
- A. Option C
- B. Option D
- C. Option A
- D. Option B
Answer: B
NEW QUESTION # 104
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.
Answer:
Explanation:
NEW QUESTION # 105
Which two configurations are available by using a service profile template in Cisco UCS Manager? (Choose two.)
- A. target server
- B. UUID assignment
- C. number of vHBAs
- D. ARP entries
- E. VXLAN membership
Answer: B,C
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/cli/config/guide/2-
2/b_UCSM_CLI_Configuration_Guide_2_2/b_UCSM_CLI_Configuration_Guide_2_2_chapter_01
00000.html
NEW QUESTION # 106
Refer to the exhibit.
Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?
- A. Primary
- B. Updating
- C. Initial
- D. Secondary
Answer: C
NEW QUESTION # 107
An engineer must use OTV for layer 2 connectivity between data centers to support virtual machine between the customer sites. To support this requirement, the engineer must ensure the existence of the same default gateway on both sites. Additionally, the operations team report high bandwidth utilization on site A and wants to optimize the outbound traffic flows to use a DC exit point. Which feature must be used to meet these requirement?
- A. ARP filter
- B. Control group
- C. FHRP filter
- D. Data group
Answer: C
Explanation:
https://www.cisco.com/c/dam/en/us/products/collateral/switches/nexus-7000-series-switches/guide_c07-728315.pdf
NEW QUESTION # 108
Refer to the exhibit. The security team created a new security policy that requires certain types of traffic to be subject to deep packet inspection. The traffic types are:
- internet traffic to application servers
- internet traffic to corporate users
- partner network traffic to application servers
- partner network traffic to corporate users
Where must the next-generation firewalls be inserted to implement the new policy?
- A. inline insertion between the user network switch cluster and the core cluster
- B. inline insertion between the edge router duster and the core switch duster
- C. one-armed insertion from the core switch cluster
- D. one-armed insertion from the ACl border leaf duster
Answer: D
NEW QUESTION # 109
What can be implemented on Cisco Nexus 5600 Series Switches for link redundancy within a Fibre Channel fabric?
- A. E-Trunk
- B. SAN port channel
- C. vPC+
- D. LACP port channel
Answer: D
Explanation:
Section: Compute Design
NEW QUESTION # 110
A company needs a solution to virtualize their legacy desktop computers. The solution must be highly resilient and able to withstand the loss of a data center site.
Each compute node requires a minimum of 20 disk drives.
Which solution meets these requirements?
- A. *virtual desktop infrastructure solution installed in multiple data centers that are close to the end users
*solution based on Cisco HX240 compute nodes - B. *dedicated virtual machine per hypervisors for each user in a centralized data center
*solution based on Cisco HX220 compute nodes - C. *thin client installed at each user's end station with a separate profile to retrieve sensitive data using the RDP protocol
*solution based on Cisco HX220 compute nodes - D. *data center site with a strict security policy that provides access to users using a bespoke software client
*solution based on Cisco HX240 compute nodes
Answer: A
NEW QUESTION # 111
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. FC switching mode
- B. FC end-host mode
- C. NPV mode
- D. NPIV mode
Answer: A
NEW QUESTION # 112
Drag and drop the configurations from the left onto the correct policies on the right.
Answer:
Explanation:
NEW QUESTION # 113
......
To prepare for the Cisco 300-610 exam, candidates should have a solid understanding of networking technologies and protocols, storage technologies, virtualization technologies, and automation tools. They should also have experience working with Cisco data center technologies, including Cisco Nexus switches, Cisco UCS servers, and Cisco ACI. Candidates can prepare for the exam by taking Cisco training courses, using study materials such as books and practice exams, and gaining hands-on experience designing data center solutions.
Check the Free demo of our 300-610 Exam Dumps with 330 Questions: https://www.testkingit.com/Cisco/latest-300-610-exam-dumps.html
Verified 300-610 Q&As - Pass Guarantee 300-610 Exam Dumps: https://drive.google.com/open?id=17bK-WqpHpy5zgghcuQzTDWf7_tFdkn1M